Technology of infrared radiation polarizer

2020

Полный текст Открытый доступ: Gold Метаданные (CSL-JSON)
DOI 10.1117/12.2569786
Достоверность данных 70 средняя
Как считается эта оценка

Складывается из проверяемых признаков самой записи: есть ли у статьи DOI, сколько независимых источников подтвердили её данные, заполнены ли обязательные поля и насколько свежо последнее подтверждение. Снижают оценку расхождения между источниками и отсутствие идентификатора. Значение от 80 означает, что запись опубликована без дополнительной проверки; от 60 до 79 — что она опубликована с пониженной достоверностью и ручная проверка желательна. Запись, выверенную редактором вручную, пересчёт не опускает ниже 90. Это оценка наших данных о статье, а не оценка самой статьи.

Аннотация

Among the various characteristics of infrared radiation, the degree of polarization is not often used in radiation analysis. The main reason is that polarization is less informative characteristic compared to others for most practical tasks. Also obtaining polarized radiation in infrared spectrum is relative complex and expensive act. In some cases, such as remote sensing, the improvement of spatial, radiometric and spectral resolution approaches it’s physical limit. It becomes relevant to obtain additional information of a different nature, such as polarization information. Modern infrared radiation polarizers based on diffraction gratings are quite expensive. The article explores the possibility of creating infrared polarizers based on a planeparallel plate, to which radiation falls at an Brewster angle. It is shown that the polarizer operating on transmittance will be more efficient than reflecting radiation polarizer, since it does not deviate the optical axis by a significant angle. Such a polarizer provides a polarization degree of 90% and a transmittance of about 50%.