High Performance Metal Sulfide Electrode for Lithium Battery

2020

Закрытый доступ Метаданные (CSL-JSON)
DOI 10.1149/ma2020-012300mtgabs
Достоверность данных 70 средняя
Как считается эта оценка

Складывается из проверяемых признаков самой записи: есть ли у статьи DOI, сколько независимых источников подтвердили её данные, заполнены ли обязательные поля и насколько свежо последнее подтверждение. Снижают оценку расхождения между источниками и отсутствие идентификатора. Значение от 80 означает, что запись опубликована без дополнительной проверки; от 60 до 79 — что она опубликована с пониженной достоверностью и ручная проверка желательна. Запись, выверенную редактором вручную, пересчёт не опускает ниже 90. Это оценка наших данных о статье, а не оценка самой статьи.

Аннотация

The energy crisis is reaching its critical point where the actions for its mitigation cannot be postponed any longer. Therefore, urgency for more powerful, more stable energy storage systems is making our society investigate different materials with various configurations. Conducted studies on electrode materials, in general, have shown the essential tendencies besides electrode material itself being morphology, microstructure and chemical composition [1]. One of the promising electrode materials for the next-generation lithium-ion batteries is metal sulfides, as they possess high electronic conductivity and relatively high theoretical capacity than that of LiCoO2. Nowadays, copper sulfide is attracting more researchers due to its wide range of stoichiometric composition (CuxS, x=1-2) and diverse application in energy devices [2]. Extensive studies have demonstrated the possibility for numerous copper sulfide synthesis methods such as hydrothermal and solvothermal methods, melt diffusion, mixed solvents method, chemical deposition, sol-gel method, spray pyrolysis (SP), microwave-assisted growth, chemical vapor transport, template synthesis, and electrodeposition [3,4]. However, all those methods are costly and time-consuming. In this study, is presented a simple and straightforward novel method of preparation of flower-like structured copper sulfide (CuxS) (Fig. 1) with excellent electrochemical properties and cycling stability. Detailed studies of the electrochemical reaction mechanism for the new composition of CuxS phase will be presented. References [1] G. Zubiab, R. Dufo-López, M. Carvalho, G. Pasaoglu, Renew. Sust. Energ. Rev., 89 (2018) 292-308. [2] C. Feng, L. Zhang, Z. Wang, X. Song, K. Sun, F. Wu, G. Liu, J. Power Sources, 269 (2014) 550-555. [3] G. Kalimuldina, I. Taniguchi, J. Mater. Chem. A, 5 (2017) 6937-6946. [4] C. Feng, L. Zhang, M. Yang,. X. Song, H. Zhao, Z. Jia, K. Sun, G. Liu, ACS Appl. Mater. Interfaces, 7 (2015), 15726−15734. Acknowledgements This work was supported by the projects 091019CRP2114 “Three-Dimensional All Solid State Rechargeable Batteries” and 240919FD3914 “Self-charging rechargeable lithium-ion battery” from Nazarbayev University. Figure 1