Аннотация
The article presents the results of the study performance of cone crushers and the existing technology restoration of their parts. The main reasons for the failure of cone crushers are the following: failure armor of the cone and the middle part, the protective cap, parts of the upper suspension, dust seal rings, bearing rings, the eccentric of the crusher. The most time-consuming is to restore the details of the eccentric crusher. A new technology restoration worn surfaces of the eccentric part and the results of an experimental study of thermal friction treatment (TFТ) after surfacing are proposed. It is revealed that despite the high level of temperature corresponding to intensive treatment modes it is possible to achieve effective hardening. Implementation of the proposed technology allows: eliminate the undesirable effects of softening due to re-riveting and reduce the oxidized layer; increase productivity relative to mechanical cutting methods in 23 times and tool life of more than 10 times; the use of affordable cheap material steel 45, 50, 60G for the manufacture of tools and perform processing at more intensive modes S =0,2-1mm / Rev; n=2000-3000 rpm. It is established that the TFO of the deposited surface part eccentric, provides wear resistance of the treated surfaces parts in 2….8 times more than the factory processing technology, while the depth of the hardened layer can be 1.5…. 2 mm.