Synthesis and Catalytic Properties of Polymer-Immobilized Nanoparticles of Cobalt and Nickel

2018

Закрытый доступ Метаданные (CSL-JSON)
DOI 10.18412/1816-0387-2018-3-8-15
Достоверность данных 70 средняя
Как считается эта оценка

Складывается из проверяемых признаков самой записи: есть ли у статьи DOI, сколько независимых источников подтвердили её данные, заполнены ли обязательные поля и насколько свежо последнее подтверждение. Снижают оценку расхождения между источниками и отсутствие идентификатора. Значение от 80 означает, что запись опубликована без дополнительной проверки; от 60 до 79 — что она опубликована с пониженной достоверностью и ручная проверка желательна. Запись, выверенную редактором вручную, пересчёт не опускает ниже 90. Это оценка наших данных о статье, а не оценка самой статьи.

Аннотация

It is shown that copolymers of poly-(ethylene)-propyleneglycolmaleates (p-EGM and p-PGM) with acrylic acid (AA) can be used as matrices for preparation of effective metal-polymer complexes for hydrogenation of organic compounds. Electron microscopic and dynamic scattering techniques were used for determining the average nanoparticle size equal to 112 nm; the nanoparticles are spheres with uniform distribution along the polymer cross-section. The nickel and cobalt contents are 0.52 and 0.48 wt %, respectively, in p-EGM/AA, 0.49 and 0.51 wt %, respectively, in p-PGM/AA. The temperature elevation from 25 to 40 °C allows the rate of pyridine hydrogenation to be increased due to the catalyst activation, and the number of catalyst active centers to be increased due to swelling of the polymer network and its transition from tight globular to expanded state. An increase in the current strength from 1 to 3 A results in a decrease in the pyridine yield that does not allow current density to be increased in order to shorten the synthesis time. The obtained experimental data make it possible to obtain the target hydrogenation product at higher rates and yields.