3D Visualization of the Results of Using Modern Ofa Technology on the Example of Real Boiler

2022

Полный текст Открытый доступ: Gold Метаданные (CSL-JSON)
DOI 10.37394/232013.2021.16.22
Достоверность данных 70 средняя
Как считается эта оценка

Складывается из проверяемых признаков самой записи: есть ли у статьи DOI, сколько независимых источников подтвердили её данные, заполнены ли обязательные поля и насколько свежо последнее подтверждение. Снижают оценку расхождения между источниками и отсутствие идентификатора. Значение от 80 означает, что запись опубликована без дополнительной проверки; от 60 до 79 — что она опубликована с пониженной достоверностью и ручная проверка желательна. Запись, выверенную редактором вручную, пересчёт не опускает ниже 90. Это оценка наших данных о статье, а не оценка самой статьи.

Аннотация

The leading place in the world for environmental protection is currently occupied by the protection of the air basin. And the main sources of atmospheric pollution are industrial enterprises, motor transport and thermal power plants. Thus, there is an obvious need to increase attention to the problems of the innovation sector, mainly in the areas of technical improvement of heat and power industry enterprises. Therefore, the study of the problems of reducing the amount of harmful emissions into the atmosphere, control and regulation of its quality, as well as the study of new various methods of innovative development of thermal power is an urgent task at present, requiring a serious scientific approach. In the proposed work, computer experiments were carried out in the field of innovative energy production technologies (the use of modern "sharp blast" OFA technology) at a specific thermal power facility of the enterprise of the Republic of Kazakhstan. During the experiment, various ways of supplying additional air through OFA nozzles were investigated: OFA=0% (basic version without additional air supply), OFA=10% and OFA=18%. For these three modes, a comparative analysis of the aerodynamics of the furnace part of the boiler was performed according to the obtained distributions of the temperature and concentration fields of nitrogen oxide NO over the entire volume of the combustion chamber. The results obtained were compared with experimental data obtained during experiments conducted directly at the CHP.