Fabrication of Superhydrophobic Self-Cleaning Coatings by Facile Method: Stable after Exposure to Low Temperatures and UV Light

2022

Закрытый доступ Метаданные (CSL-JSON)
DOI 10.31489/2022ch3/3-22-14
Достоверность данных 70 средняя
Как считается эта оценка

Складывается из проверяемых признаков самой записи: есть ли у статьи DOI, сколько независимых источников подтвердили её данные, заполнены ли обязательные поля и насколько свежо последнее подтверждение. Снижают оценку расхождения между источниками и отсутствие идентификатора. Значение от 80 означает, что запись опубликована без дополнительной проверки; от 60 до 79 — что она опубликована с пониженной достоверностью и ручная проверка желательна. Запись, выверенную редактором вручную, пересчёт не опускает ниже 90. Это оценка наших данных о статье, а не оценка самой статьи.

Аннотация

Self-cleaning hydrophobic surfaces attracted public attention last few decades after discovering of lotus ef-fect. Ability of lotus leaves to keep cleanness in relatively dirty places and to clean up itself during rains di-rected to the development of novel materials and surface structure modification. The surface with such smart properties may have the potential for cost-effectiveness in the case of application in skyscrapers, high build-ings, etc. Two main criteria for the surface to express hydrophobic behavior are roughness and low surface energy of the coating material. In this study, superhydrophobic self-cleaning coatings were prepared by a simple, facile, and cheap method using easily available materials, such as polydimethylsiloxane (PDMS) and TiO2 nanoparticles, and fully characterized for direct usage. PDMS is a bonding layer and TiO2 nanoparticles are a reinforced composite to form roughness, which shows superhydrophobicity. Characterizations showed that the prepared superhydrophobic coating has a water contact angle of up to 165.5°, with sliding angle of less than 5º. Also self-cleaning and surface microfluidic properties have been studied. The superhydrophobic properties of these coatings do not change even after exposure to their surface to low temperatures and UV light. SEM images confirm the rough structure of obtained surface on glass and sand grains.