UV-Synthesized Polyacrylamide-Based Polymer Sensor for Measuring Soil–Water Characteristic Curves in Unsaturated Soils

2026

Полный текст Открытый доступ: Gold Метаданные (CSL-JSON)
DOI 10.3390/polym18141692
Достоверность данных 70 средняя
Как считается эта оценка

Складывается из проверяемых признаков самой записи: есть ли у статьи DOI, сколько независимых источников подтвердили её данные, заполнены ли обязательные поля и насколько свежо последнее подтверждение. Снижают оценку расхождения между источниками и отсутствие идентификатора. Значение от 80 означает, что запись опубликована без дополнительной проверки; от 60 до 79 — что она опубликована с пониженной достоверностью и ручная проверка желательна. Запись, выверенную редактором вручную, пересчёт не опускает ниже 90. Это оценка наших данных о статье, а не оценка самой статьи.

Аннотация

This study presents the development and evaluation of a hydrogel-based superabsorbent polymer sensor (HSPS) for measuring soil suction and establishing the soil-water characteristic curve (SWCC) of unsaturated soils. Polyacrylamide (PAM) hydrogels were synthesized via UV-induced free radical polymerization using acrylamide with varying crosslinking degrees. The polymers were characterized through FT-IR and TGA analyses, confirming successful synthesis and high thermal stability. Swelling, water retention, and kinetic behavior were systematically investigated. Results indicated that lower crosslinking density significantly enhanced swelling capacity, reaching up to 3000% in distilled water, while saline environments reduced absorption due to ionic screening effects. Swelling kinetics followed anomalous (non-Fickian) diffusion behavior and were well described by the pseudo-second-order Schott model. The synthesized polymers were integrated into a modified high-sensitivity pressure sensor operating on the osmotic principle to measure matric suction. The system was validated using natural soil. Among the tested formulations, the HSPS-3 demonstrated the most reliable suction measurements, reaching values up to approximately 1 MPa without significant temperature sensitivity. The resulting SWCC exhibited bimodal characteristics consistent with the soil's dual pore structure. The proposed method provides a cost-effective, simple, and efficient alternative for suction measurement, expanding the practical range of SWCC determination in unsaturated soil mechanics.