Method for determining angles in x-ray emulsion chambers

Recent Contributions to Physics, 2019

Полный текст Открытый доступ: Gold Метаданные (CSL-JSON)
DOI 10.26577/rcph-2019-i2-9
Достоверность данных 70 средняя
Как считается эта оценка

Складывается из проверяемых признаков самой записи: есть ли у статьи DOI, сколько независимых источников подтвердили её данные, заполнены ли обязательные поля и насколько свежо последнее подтверждение. Снижают оценку расхождения между источниками и отсутствие идентификатора. Значение от 80 означает, что запись опубликована без дополнительной проверки; от 60 до 79 — что она опубликована с пониженной достоверностью и ручная проверка желательна. Запись, выверенную редактором вручную, пересчёт не опускает ниже 90. Это оценка наших данных о статье, а не оценка самой статьи.

Аннотация

An analysis of the measurement procedure for the zenith and azimuth angles υ and φ in the X-ray emulsion chambers (XREC) of ADRON and PAMIR experiments is presented. Earlier, asymmetry was observed in distributions of azimuth angles of gamma and hadron families. A detailed analysis of methodological errors in measuring θ, φ angles allowed us to establish the causes of the distortion of azimuth angles distributions. There are two reasons: systematic errors in the measurement of zenith angles by MBS-2 microscopes, used both in the PAMIR experiment, and in the ADRON experiment, and the inclination of XREC based on the subsidence. Calculations showed that the total systematic error Δυ≈4 ° completely explains the observed azimuthal asymmetry. Formulas for correcting θ and φ angles are given. The recalculation of the angles by the indicated formulas showed that this corrects the distribution of the azimuthal angles φ. The REC plane should be set relative to the horizontal with an accuracy of no worse than 1 degree in order to avoid distortion of the angular distributions.