A study of the possibilities of using linseed flour and rice husk fiber as an additional source of raw materials in the bakery industry

2021

Полный текст Открытый доступ: Gold Метаданные (CSL-JSON)
DOI 10.15587/1729-4061.2021.242648
Достоверность данных 70 средняя
Как считается эта оценка

Складывается из проверяемых признаков самой записи: есть ли у статьи DOI, сколько независимых источников подтвердили её данные, заполнены ли обязательные поля и насколько свежо последнее подтверждение. Снижают оценку расхождения между источниками и отсутствие идентификатора. Значение от 80 означает, что запись опубликована без дополнительной проверки; от 60 до 79 — что она опубликована с пониженной достоверностью и ручная проверка желательна. Запись, выверенную редактором вручную, пересчёт не опускает ниже 90. Это оценка наших данных о статье, а не оценка самой статьи.

Аннотация

The paper is devoted to solving the problem of the nutritional and biological value of rye-wheat bread by enriching it with non-traditional local plants raw materials – linseed flour and rice husk fiber. Rice husks are rarely used in bakery production, and in most cases remain unprocessed. However, this research defined the right ways for using them and set as a preliminary work in this field. The study has been carried out in two stages: firstly, linseed flour was added to the rye-wheat bread recipe in an amount of 5; 10; 15; 20 % to the weight of wheat flour. Secondly, dietary fiber was added to these experimental samples, prepared from rice husks without removing amorphous silicon dioxide in an amount of 0.3; 0.5; 0.7 % to the total mass of rye-wheat flour. The optimization of the ratios of the flour components with a simplex-lattice design was carried out and the rheological measurements of dough and bread were conducted on the farinograph and Chopin alveograph. The study results experimentally found that mixtures of rye-wheat flour and linseed flour with the addition of fiber as “medium in strength” give bread with sufficient volume. The recipe optimization parameters indicated that rational percentage of fiber and linseed flour up to 0.5 % and 15 %, respectively allows increasing the nutritional and biological value of finished products, improves the crumb structure, gas-holding and water-holding capacity of bread, which in turn prevents the stale process and thereby increases the shelf life of finished products. The obtained results allow us to suggest that, this recipe optimization model could be used in further research, as studies in this direction are limited