Periodic solutions of a graphene based model in micro-electro-mechanical pull-in device

2017

Полный текст Открытый доступ: Gold Метаданные (CSL-JSON)
DOI 10.24132/acm.2017.322
Достоверность данных 70 средняя
Как считается эта оценка

Складывается из проверяемых признаков самой записи: есть ли у статьи DOI, сколько независимых источников подтвердили её данные, заполнены ли обязательные поля и насколько свежо последнее подтверждение. Снижают оценку расхождения между источниками и отсутствие идентификатора. Значение от 80 означает, что запись опубликована без дополнительной проверки; от 60 до 79 — что она опубликована с пониженной достоверностью и ручная проверка желательна. Запись, выверенную редактором вручную, пересчёт не опускает ниже 90. Это оценка наших данных о статье, а не оценка самой статьи.

Аннотация

Phase plane analysis of the nonlinear spring-mass equation arising in modeling vibrations of a lumped mass attached to a graphene sheet with a fixed end is presented. The nonlinear lumped-mass model takes into account the nonlinear behavior of the graphene by including the third-order elastic stiffness constant and the nonlinear electrostatic force. Standard pull-in voltages are computed. Graphic phase diagrams are used to demonstrate the conclusions. The nonlinear wave forms and the associated resonance frequencies are computed and presented graphically to demonstrate the effects of the nonlinear stiffness constant comparing with the corresponding linear model. The existence of periodic solutions of the model is proved analytically for physically admissible periodic solutions, and conditions for bifurcation points on a parameter associated with the third-order elastic stiffness constant are determined..