Inertial motion capture based reference trajectory generation for a mobile manipulator

2014

Закрытый доступ Метаданные (CSL-JSON)
DOI 10.1145/2559636.2559812
Достоверность данных 85 высокая
Как считается эта оценка

Складывается из проверяемых признаков самой записи: есть ли у статьи DOI, сколько независимых источников подтвердили её данные, заполнены ли обязательные поля и насколько свежо последнее подтверждение. Снижают оценку расхождения между источниками и отсутствие идентификатора. Значение от 80 означает, что запись опубликована без дополнительной проверки; от 60 до 79 — что она опубликована с пониженной достоверностью и ручная проверка желательна. Запись, выверенную редактором вручную, пересчёт не опускает ниже 90. Это оценка наших данных о статье, а не оценка самой статьи.

Аннотация

This paper presents a human-robot interaction system integrating a mobile manipulator with a full-body inertial motion capture suit. The framework aims to provide an intuitive, effective and easy-to-deploy teleoperation interface. User control intent is acquired by the motion capture system in real-time, processed and relayed to the mobile manipulator wirelessly. Specifically, body center of mass and the right hand kinematic data of the user are used to generate position and orientation references for the robot base and manipulator, respectively. The left arm is employed to provide high-level user commands such as "Manipulator On/Off", "Base On/Off" and "Manipulator Pause/Resume". The efficacy of the presented system was demonstrated in real-time teleoperation experiments using KUKA youBot mobile manipulator accomplishing pick-and-place tasks.