Compositional Fibers Based on Coal Tar Mesophase Pitch Obtained by Electrospinning Method

2021

Закрытый доступ Метаданные (CSL-JSON)
DOI 10.23939/chcht15.03.403
Достоверность данных 70 средняя
Как считается эта оценка

Складывается из проверяемых признаков самой записи: есть ли у статьи DOI, сколько независимых источников подтвердили её данные, заполнены ли обязательные поля и насколько свежо последнее подтверждение. Снижают оценку расхождения между источниками и отсутствие идентификатора. Значение от 80 означает, что запись опубликована без дополнительной проверки; от 60 до 79 — что она опубликована с пониженной достоверностью и ручная проверка желательна. Запись, выверенную редактором вручную, пересчёт не опускает ниже 90. Это оценка наших данных о статье, а не оценка самой статьи.

Аннотация

This research examines the use of coal-processing wastes of Shubarkol deposit (Kazakhstan) in obtaining useful materials such as carbon fibers. For our experiments, mesophase pitch was obtained by coal tar heat treatment at 773 K. Spinnable solution was prepared by crushing mesophase pitch into the pieces with adding poly(methylmethacrylate) as a fiber-forming material and 1,2-dichloroethane as a solvent. Elemental analysis revealed that the chemical composition of mesophase pitch (С – 91.48 %; О – 8.52 %; S – 0.00 %) showed that heat treatment up to 773 K leads to the complete removal of sulfur-containing components which affect the mesophase formation. Raman data of the obtained pitch revealed the appearance of D (1366 cm-1) and G (1605 cm-1) peaks, which are responsible for carbon materials; another peak at 2900 cm-1 shows the presence of C–H bonds. Carbon fibers with the diameter of 0.8–1.75 μm were obtained by electrospinning method in laboratory settings.