Determination of natural modes of railway overpasses

2021

Полный текст Открытый доступ: Gold Метаданные (CSL-JSON)
DOI 10.22201/icat.24486736e.2021.19.1.1487
Достоверность данных 70 средняя
Как считается эта оценка

Складывается из проверяемых признаков самой записи: есть ли у статьи DOI, сколько независимых источников подтвердили её данные, заполнены ли обязательные поля и насколько свежо последнее подтверждение. Снижают оценку расхождения между источниками и отсутствие идентификатора. Значение от 80 означает, что запись опубликована без дополнительной проверки; от 60 до 79 — что она опубликована с пониженной достоверностью и ручная проверка желательна. Запись, выверенную редактором вручную, пересчёт не опускает ниже 90. Это оценка наших данных о статье, а не оценка самой статьи.

Аннотация

Currently, there are many software systems and environments that allow you to simulate and perform fairly complex and voluminous calculations associated with dynamic effects on structural elements of overpasses. The aim of the article is to make an analysis of a reinforced concrete railway overpass as a whole and its elements separately. The article presents the calculated and experimental data of the forms and frequencies of natural vibrations of reinforced concrete railway overpasses under constant loads and the rolling stock off the span. As a result of the analysis of the tests, it was determined that the effect of the rolling stock passing through the reinforced concrete beam spans of 16.5 m and 23.6 m appears with frequency perturbations that are in the range f = 4.41 ÷ 9.52 Hz. These studies can be further used in the design of artificial structures, as well as to identify defects in structural elements of railway bridges.