Light attenuation parameters for waste stabilisation ponds

2005

Закрытый доступ Метаданные (CSL-JSON)
DOI 10.2166/wst.2005.0450
Достоверность данных 70 средняя
Как считается эта оценка

Складывается из проверяемых признаков самой записи: есть ли у статьи DOI, сколько независимых источников подтвердили её данные, заполнены ли обязательные поля и насколько свежо последнее подтверждение. Снижают оценку расхождения между источниками и отсутствие идентификатора. Значение от 80 означает, что запись опубликована без дополнительной проверки; от 60 до 79 — что она опубликована с пониженной достоверностью и ручная проверка желательна. Запись, выверенную редактором вручную, пересчёт не опускает ниже 90. Это оценка наших данных о статье, а не оценка самой статьи.

Аннотация

Effective modelling of shallow water ecosystems, including waste stabilisation ponds, is strongly dependent on the availability of good estimates of the light attenuation coefficient k (m(-1)). Experimental data is presented on its determination using purpose-built laboratory apparatus with a near-parallel halogen light source and an array of photodiodes allowing measurements of irradiance at different depths. The equipment was used to compare k values from 4 different pure cultures, and mixed cultures of algae taken from a pilot-scale WSP. Laboratory values were compared with in situ measurements in the pond. At concentrations above 50 mg l(-1) the relationship between k and suspended solids is non-linear; k also varied with depth. This could be modelled by a single equation, suggesting similarity of response in different cultures. At shallow depths and low suspended solids concentrations k values are variable and hard to measure reliably. The results highlight the need to standardise on a method for the measurement and reporting of k values if these are to be widely applicable in the development of pond models.