Polyurethane–poly(2-hydroxyethyl methacrylate) semi-IPN–nanooxide composites

2013

Закрытый доступ Метаданные (CSL-JSON)
DOI 10.1039/c3ra40295a
Достоверность данных 70 средняя
Как считается эта оценка

Складывается из проверяемых признаков самой записи: есть ли у статьи DOI, сколько независимых источников подтвердили её данные, заполнены ли обязательные поля и насколько свежо последнее подтверждение. Снижают оценку расхождения между источниками и отсутствие идентификатора. Значение от 80 означает, что запись опубликована без дополнительной проверки; от 60 до 79 — что она опубликована с пониженной достоверностью и ручная проверка желательна. Запись, выверенную редактором вручную, пересчёт не опускает ниже 90. Это оценка наших данных о статье, а не оценка самой статьи.

Аннотация

Two sets of hybrid polyurethane–poly(2-hydroxyethyl methacrylate) semi-interpenetrating polymer network–nanooxide composites with 0.25 or 3 wt% nanosilica or nanoalumina functionalised with OH, NH2 or CHCH2 groups were prepared. A combination of atomic force microscopy, infrared spectroscopy, thermally stimulated depolarisation current measurement, differential scanning calorimetry and creep rate spectroscopy analysis of the nanostructure and properties of the composites was performed. The pronounced dynamic heterogeneity and the strong impact of oxide additives, basically suppression of the dynamics and temperature-dependent increasing modulus of elasticity, were observed. The effects correlated with either interfacial interactions (for silica) or the nanostructure (for alumina). A low oxide content strongly affected the matrix due to the formation of an unusual cross-linked, via double covalent hybridisation of three components, structure of the nanocomposites.