Efficient and Reversible Bisphenol A Removal Study Based on Hydrophilic Molecularly Imprinted Polymers-Functionalized Semi-IPN Hydrogel

2026

Полный текст Открытый доступ: Hybrid Метаданные (CSL-JSON)
DOI 10.53941/sen.2026.100008
Достоверность данных 70 средняя
Как считается эта оценка

Складывается из проверяемых признаков самой записи: есть ли у статьи DOI, сколько независимых источников подтвердили её данные, заполнены ли обязательные поля и насколько свежо последнее подтверждение. Снижают оценку расхождения между источниками и отсутствие идентификатора. Значение от 80 означает, что запись опубликована без дополнительной проверки; от 60 до 79 — что она опубликована с пониженной достоверностью и ручная проверка желательна. Запись, выверенную редактором вручную, пересчёт не опускает ниже 90. Это оценка наших данных о статье, а не оценка самой статьи.

Аннотация

Bisphenol A (BPA), as a typical endocrine-disrupting compound, is present in water and severely threatens both ecosystems and human health. This study reports the doping of hydrophilic molecularly imprinted polymers (MIPs) into an N-isopropylacrylamide/carboxymethyl chitosan (N/C) semi-interpenetrating network (semi-IPN) hydrogel to yield a novel gel membrane (MIP@N/C) with exceptional adsorption performance for BPA. Experimental results revealed that MIP@N/C exhibited a maximum BPA adsorption capacity of 113.66 mg/g, with its adsorption behavior well-described by the Freundlich isotherm and pseudo-second-order kinetic models. The ethanol-triggered solvent responsiveness of MIP@N/C facilitated its rapid elution regeneration. The material retained 99% of its initial adsorption efficiency after six cycles, and even after twelve cycles the removal efficiency remained as high as 97.73%, demonstrating outstanding regenerability. This work overcomes the limitations of traditional adsorbents, such as poor selectivity and difficulty in recovery, providing a new strategy for the efficient removal of pollutants from water.