ECOLOGICAL ASSESSMENT OF OPTIONS FOR MODERNIZATION OF THE ALMATY THERMAL POWER PLANT WITH THE AIM OF MINIMIZING THE ENVIRONMENTAL IMPACT

2026

Полный текст Открытый доступ: Hybrid Метаданные (CSL-JSON)
DOI 10.54668/2789-6323-2026-121-1-124-132
Достоверность данных 70 средняя
Как считается эта оценка

Складывается из проверяемых признаков самой записи: есть ли у статьи DOI, сколько независимых источников подтвердили её данные, заполнены ли обязательные поля и насколько свежо последнее подтверждение. Снижают оценку расхождения между источниками и отсутствие идентификатора. Значение от 80 означает, что запись опубликована без дополнительной проверки; от 60 до 79 — что она опубликована с пониженной достоверностью и ручная проверка желательна. Запись, выверенную редактором вручную, пересчёт не опускает ниже 90. Это оценка наших данных о статье, а не оценка самой статьи.

Аннотация

Converting combined heat and power plants (CHPs) to natural gas combustion is an effective way to reduce harmful emissions and improve air quality in the plant's footprint. Conversion to natural gas virtually eliminates air pollution from coal ash, sulfur dioxide, and fuel oil ash. It also reduces nitrogen and carbon oxide pollution, and lowers greenhouse gas emissions. Converting CHPs to natural gas combustion will reduce annual pollutant emissions by approximately 80%. The main objective of the study is to identify a modernization option for the Almaty CHP that minimizes environmental impact without compromising the reliability and efficiency of energy supply, while increasing installed capacity utilization, reliability, and operational safety. The study examines two CHP development scenarios: coal-fired and gas-fired. The recommended option for modernizing the combined heat and power plant is the construction of a new source - a gas turbine combined heat and power plant - with a variant study based on modern gas turbine units (GTU) of various types in order to determine the optimal option that will meet the requirements for covering electrical and thermal loads.