Inverse heat conduction problems with boundary and final time measured output data

2011

Закрытый доступ Метаданные (CSL-JSON)
DOI 10.1080/17415977.2011.565931
Достоверность данных 70 средняя
Как считается эта оценка

Складывается из проверяемых признаков самой записи: есть ли у статьи DOI, сколько независимых источников подтвердили её данные, заполнены ли обязательные поля и насколько свежо последнее подтверждение. Снижают оценку расхождения между источниками и отсутствие идентификатора. Значение от 80 означает, что запись опубликована без дополнительной проверки; от 60 до 79 — что она опубликована с пониженной достоверностью и ручная проверка желательна. Запись, выверенную редактором вручную, пересчёт не опускает ниже 90. Это оценка наших данных о статье, а не оценка самой статьи.

Аннотация

This article presents a systematic study of inverse problems of identifying the unknown source term F(x, t) of the heat conduction (or linear parabolic) equation ut = (k(x)ux)x + F(x, t) from measured output data in the form of Dirichlet h(t) ≔ u(0, t), Neumann f(t) ≔ −k(0)ux(0, t) types of boundary conditions, also in the form the final time overdetermination uT(x) ≔ u(x, T). In the first part of this article the adjoint problem approach is used to derive formulas for the Fréchet gradient of cost functionals via solutions of the corresponding adjoint problems. It is proved that all these gradients are Lipschitz continuous. A necessary conditions for unicity and hence distinguishablity of solutions of all the three types of inverse source problems are derived. In the second part of this article the semigroup theory is used to obtain a general representation of a solution of the inverse source problem for the abstract evolution equation ut = Au + F with final data overdetermination. This representation shows non-uniqueness structure of the inverse problem solution, and also permits one to derive a sufficient condition for unicity.