Аннотация
Spent water-based drilling fluids generated during technological-well drilling for uranium production are high-solid, chemically heterogeneous suspensions whose treatment is constrained by water scarcity, waste-handling requirements, reagent demand and electrical-energy consumption. This study evaluated a recirculating flow-through disperser that converts pressure-driven flow into controlled nominal velocity gradients and localized contact zones. The laboratory-pilot dataset comprised five high-solid water-based spent-fluid samples, 120 hydrodynamic treatment runs, 216 particle-size-bin observations corresponding to 12 complete distributions, nine mechanical-mixing baseline tests and ten repeated-cycle runs. The investigated range covered nominal Camp–Stein-equivalent velocity gradients of 500–1500 s−1, treatment times of 60–180 s and flocculant dosages of 0–100 g/t dry solids. A 50 L batch was recirculated through a disperser with a cylindrical geometric envelope of approximately 4.75 L. The maximum separation efficiency was 94.20%. The recommended compromise condition (G = 1300 s−1, τ = 150 s and 50 g/t dry solids) achieved 92.15 ± 1.81% separation efficiency, residual aqueous-phase TSS of 125.2 ± 30.0 mg/L, water recovery of 83.84 ± 0.28%, sludge-volume reduction of 59.02 ± 2.11% and wall-plug specific energy consumption of 0.1227 ± 0.0062 kWh/m3. A separate ten-cycle series yielded 0.1245 ± 0.0065 kWh/m3, consistent with the triplicate compromise-mode result. Two-factor response-surface models reproduced the measured G–τ trends and provided prediction intervals for operating-window screening within the investigated fluid class. The findings support coupled energy–separation optimization, rather than selection of the maximum nominal mixing intensity.