The influence of variation in the ratio of components in two-phase lithium-containing ceramics on defect formation processes

Nuclear Materials and Energy, 2025

Полный текст Открытый доступ: Gold Метаданные (CSL-JSON)
DOI 10.1016/j.nme.2025.101980
Достоверность данных 70 средняя
Как считается эта оценка

Складывается из проверяемых признаков самой записи: есть ли у статьи DOI, сколько независимых источников подтвердили её данные, заполнены ли обязательные поля и насколько свежо последнее подтверждение. Снижают оценку расхождения между источниками и отсутствие идентификатора. Значение от 80 означает, что запись опубликована без дополнительной проверки; от 60 до 79 — что она опубликована с пониженной достоверностью и ручная проверка желательна. Запись, выверенную редактором вручную, пересчёт не опускает ниже 90. Это оценка наших данных о статье, а не оценка самой статьи.

Аннотация

The aim of this study is to determine the effect of changing the ratio of components in the composition of two-component xLi 2 TiO 3 − (1-x)Li 2 ZrO 3 ceramics on structural distortions and degradation of strength and thermal parameters under high-dose neutron irradiation. The assessment of structural changes was carried out using the electron paramagnetic resonance (EPR) method, which is one of the most accurate methods that allows for a quantitative and qualitative assessment of structural changes caused by irradiation, as well as determining the concentrations of various types of defects depending on the irradiation fluence. It was found that in the case of two-component lithium-containing ceramics, the resistance to accumulation of radiolysis products is due to the effects of the presence of interphase boundaries that inhibit the formation of radiolysis products. According to the qualitative assessment of the EPR spectra, it was established that in the case of two-component ceramics, the formation of HC 2 – centers occurs at higher irradiation fluences (above 5 × 10 20 neutron/cm 2 ), while for one-component ceramics, the formation of radiolysis products is observed at irradiation fluences above 10 19 neutron/cm 2 . In this case, a comparative analysis of the concentrations of defects formed in the damaged layer and their evolution indicates an increase in resistance to defect formation processes due to a change in the ratio of components in the composition of two-component ceramics. The improved stability of two-component ceramics against disordering and defect accumulation is attributed to grain boundaries, which act as barriers to oxygen vacancy migration and defect clustering.