Аннотация
The article presents the results of finite element modeling of the sheet stamping process for obtaining metal fittings for a rubber-reinforced part "brake pad". DEFORM program considered obtaining a part by sequential cutting operations with punching and subsequent bending. In the process of computer modeling, the influence of various factors was studied: the type of separation operation, the gap between the die and the punch, the shape of the cutting punch, the use of lubricant, and other factors. The analysis of the results of computer modeling was carried out according to the level of deformation force. As a result, the most optimal parameters of the deformation process were identified: obtaining the initial workpiece for bending by cutting strips of strip metal; the gap between the punch and the die is 0.12 mm on each side during separation operations; the use of lubricants or punches with beveled edges; the gap between the punch and the die in the range of 4.4 - 4.5 mm on each side, taking into account thickness of the workpiece during U-shaped bending. Performing a bending operation at the second or third stage does not have a fundamental difference in evaluating the quality of the geometry of the parts being produced.