Changes in some agrophysical characteristics of oil-contaminated soils following their washing with polysorbate 80 solutions

Proceedings of universities Applied chemistry and biotechnology, 2025

Полный текст Открытый доступ: Gold Метаданные (CSL-JSON)
DOI 10.21285/achb.968
Достоверность данных 70 средняя
Как считается эта оценка

Складывается из проверяемых признаков самой записи: есть ли у статьи DOI, сколько независимых источников подтвердили её данные, заполнены ли обязательные поля и насколько свежо последнее подтверждение. Снижают оценку расхождения между источниками и отсутствие идентификатора. Значение от 80 означает, что запись опубликована без дополнительной проверки; от 60 до 79 — что она опубликована с пониженной достоверностью и ручная проверка желательна. Запись, выверенную редактором вручную, пересчёт не опускает ниже 90. Это оценка наших данных о статье, а не оценка самой статьи.

Аннотация

The study was aimed at comparing the effect of oil, diesel fuel, and motor oil on the capillary moisture capacity and hygroscopic moisture content of gray forest soil, as well as assessing changes in these characteristics of oil-contaminated soils following their washing with polysorbate 80. Water and a washing solution (with detergent concentrations of 1, 5, and 10 g/L) were added to the soil to be continuously mixed for 1 h at 20 °С using a shaker (60 rpm). The analyzed agrophysical characteristics of soils are shown to decrease when soils are contaminated with oil, diesel fuel, and motor oil at concentrations of 50, 150, and 300 mL/kg. The effect of motor oil on capillary moisture capacity is more pronounced than those of oil and diesel fuel at similar concentrations, while the effect on hygroscopic moisture content is, conversely, less pronounced. The washing of contaminated soils with polysorbate 80 partially restored these agrophysical characteristics; however, they remained lower than those of the original samples. The effectiveness of polysorbate 80 is also confirmed by the reduction in the phytotoxicity of contaminated soil samples following their washing with detergent solutions. At the level of oil contamination of up to 150 mL/kg, solutions containing 5 g/L of polysorbate 80 were found to be more effective, whereas at 300 mL/kg, it is recommended to increase the concentration of detergent up to 10 g/L. The recommended weight ratio of soil, washing solution, and water for soil washing is 1:1:4. Thus, the prospects for using polysorbate 80 to mitigate the negative impact of oil contamination in soil are demonstrated.