STUDY OF THE STRUCTURAL-PHASE STATE OF NITROGEN – CONTAINING COATINGS OF TITANIUM DIOXIDE SYNTHESIZED BY THE REACTIVE MAGNETRON SPUTTERING

2020

Толық мәтін Ашық қол жеткізу: Hybrid Метадеректер (CSL-JSON)
DOI 10.52676/1729-7885-2020-2-21-25
Деректер сенімділігі 70 орташа
Бұл баға қалай есептеледі

Ол жазбаның өзінің тексерілетін белгілерінен құралады: мақаланың DOI-і бар ма, оның деректерін қанша тәуелсіз дереккөз растады, міндетті өрістер толтырылған ба және соңғы растау қаншалықты жаңа. Дереккөздер арасындағы алшақтық пен идентификатордың болмауы бағаны төмендетеді. 80-нен бастап мән жазбаның қосымша тексерусіз жарияланғанын, 60-тан 79-ға дейін — оның сенімділігі төмен күйде жарияланғанын және қолмен тексеру ұсынылатынын білдіреді. Редактор қолмен тексерген жазбаны қайта есептеу 90-нан төмен түсірмейді. Бұл — мақаланың өзіне емес, ол туралы деректерімізге берілген баға.

Аңдатпа

The paper presents the results of the study of the effect of ratios of reactive gases N2 and O2 on the structural phase state and the mechanical properties of nitrogen-containing titanium dioxide coatings obtained by reactive magnetron sputtering on the surface of AISI 304 stainless steel. According to the results of the X-ray phase analysis, the coatings contain titanium dioxide in the form of anatase, rutile and a small amount of brookite. It was found that with an increase in the nitrogen content in the working atmosphere, the volume fraction of anatase and rutile increases. An increase in the nitrogen content in the gas atmosphere leads to the formation of a quasihomogeneous surface texture with a less pronounced block structure. Based on the results of nanoindentation, it can be assumed that the formation of a quasihomogeneous texture can cause a decrease in the physicomechanical parameters of the coatings. It was established that the structure, phase composition, and mechanical properties of the coatings depend on the gas ratio N2/O2 in theт negative bias mode (Ubias = −150 V).