Influence of the Ground Surface Relief on the Results of Electrical Tomography

2018

Жабық қол жеткізу Метадеректер (CSL-JSON)
DOI 10.3997/2214-4609.201802454
Деректер сенімділігі 70 орташа
Бұл баға қалай есептеледі

Ол жазбаның өзінің тексерілетін белгілерінен құралады: мақаланың DOI-і бар ма, оның деректерін қанша тәуелсіз дереккөз растады, міндетті өрістер толтырылған ба және соңғы растау қаншалықты жаңа. Дереккөздер арасындағы алшақтық пен идентификатордың болмауы бағаны төмендетеді. 80-нен бастап мән жазбаның қосымша тексерусіз жарияланғанын, 60-тан 79-ға дейін — оның сенімділігі төмен күйде жарияланғанын және қолмен тексеру ұсынылатынын білдіреді. Редактор қолмен тексерген жазбаны қайта есептеу 90-нан төмен түсірмейді. Бұл — мақаланың өзіне емес, ол туралы деректерімізге берілген баға.

Аңдатпа

Summary The Soviet geophysics S.G. Komarov and L.P. Gorbenko first noticed to the problem of the influence of ground surface relief on the distribution of electric field. The main features of the electric field anomalies, which arise on the relief were clear already then. It was found that anomalies of apparent resistivity of the minimum type arise over a positive relief forms due to a decrease of the current density, and anomalies of the maximum type arise over negative forms of relief due to an increase in the current density ( Chanturishvili, 1983 ). At the moment, the electrical tomography has a complicated situation during observations in conditions of complex Earth’s surface relief. There are several commercial inversion programs ( Loke, 1997–2000 ; Günther at al., 2017 ; Kaminsky, 2016 ; ERTLab Solver, 2017; Zonge, 1997 ) and a small number of academic programs ( De-Bao Lu at al., 2015 ; Jian-ke Qiang at al., 2013; Erdogan at al., 2008; Pidlisecky at al., 2007 , Marchenko, 1999) available to a wide range of geophysicists. However, none of these programs is open, although these programs are often successfully used in practice. Therefore, there always arises the question of the degree of reliability of those calculations that we obtain using one or another inversion code. So, it should always be remembered that the construction of the result geoelectric section is usually obtained through solving a direct problem.