Аңдатпа
This study investigates the effect of low-temperature pulsed DC plasma nitriding on the surface properties of AISI 304 stainless steel for homogenizer valve-seat components. Plasma nitriding was performed in an ammonia atmosphere at 400, 440 and 480 °C for 8 h. The treatment led to the formation of expanded austenite at 400 °C, while higher temperatures promoted the formation of Fe-N and CrN-containing phases. The thickness of the modified layer increased from approximately 36 μm at 400 °C to 65 μm at 480 °C. Surface microhardness increased from 203 HV0.1 for the untreated steel to 652.6, 806.0 and 961.8 HV0.1 after nitriding at 400, 440 and 480 °C, respectively. The wear rate decreased markedly, reaching 1.92 × 10−5 mm3/(N·m) for DCPN480 compared with 30.65 × 10−5 mm3/(N·m) for the untreated sample. Among the nitrided samples, DCPN440 showed the most favorable corrosion behavior in 3.5 wt.% NaCl solution, indicating a balance between surface hardening and preservation of corrosion resistance. Numerical modeling confirmed that the strengthened surface layer can withstand equivalent homogenizer valve-seat loading without local plastic deformation. The results demonstrate that pulsed DC plasma nitriding can significantly improve the hardness and wear resistance of AISI 304 stainless steel while maintaining acceptable corrosion performance under optimized treatment conditions.